This chapter covers the following topics:
Basic Configuration of Integrated IS-IS—Covers essential commands for configuring IS-IS.
Optional Integrated IS-IS Commands—Describes optional commands; however, note that many of these commands are commonly used to tune the required setup.
Verifying the Integrated IS-IS Operation—Looks at show commands that verify the setup.
Troubleshooting the Integrated IS-IS Operation—Describes show and debug commands that you can use to diagnose problems.
The first section of this chapter deals with the commands required to create an IS-IS routing environment. Subsequent sections cover optional commands and troubleshooting. The topics in this chapter detail the steps to configuring the IS-IS protocol for integrated routing on a Cisco network. This chapter assumes knowledge of routing protocols—in particular, link-state routing protocols—and the terminology, concepts, and operation of IS-IS.
The purpose of the "Do I Know This Already?" quiz is to help you decide what parts of this chapter to use. If you already intend to read the entire chapter, you do not necessarily need to answer these questions now.
The 12-question quiz, derived from the major sections in the "Foundation Topics" portion of the chapter, helps you determine how to spend your limited study time.
Table 10-1 outlines the major topics discussed in this chapter and the "Do I Know This Already?" quiz questions that correspond to those topics.
|Foundation Topics Section||Questions Covered in This Section||Score|
|Basic Configuration of Integrated IS-IS||1–3|
|Optional Integrated IS-IS Commands||4–6|
|Verifying the Integrated IS-IS Operation||7–10|
|Troubleshooting the Integrated IS-IS Operation||11–12|
The goal of self-assessment is to gauge your mastery of the topics in this chapter. If you do not know the answer to a question or are only partially sure of the answer, you should mark this question wrong for purposes of the self-assessment. Giving yourself credit for an answer you correctly guess skews your self-assessment results and might provide you with a false sense of security.
|1.||Which of the following is the correct command to start the Integrated IS-IS routing process?
|2.||Where is the Integrated IS-IS routing process started?
|3.||What is the purpose of the net command?
|4.||Where is the routing level changed from the default of Level 1-2?
|5.||Which of the following are valid commands for changing the routing level?
|6.||Which of the following commands summarizes the subnets 184.108.40.206 to 220.127.116.11 at the area boundary?
|7.||Which of the following are displayed in the command show clns neighbor?
|8.||Which of the following are displayed in the command show clns interface?
|9.||Which of the following are displayed in the command show isis database?
|10.||Which of the following commands shows whether the ATT bit has been set?
|11.||Which of the following are displayed in the command debug isis update-packets?
|12.||Which of the following are displayed in the command debug isis adjacency-packets?
The answers to this quiz are found in Appendix A, "Answers to Chapter 'Do I Know This Already?' Quizzes and Q&A Sections." The suggested choices for your next step are as follows: